Configured Ipv6 Multicast Group Policy Fails To Take Effect - H3C S3610 Series Operation Manual

Operation Manual – Multicast Protocol
H3C S3610&S5510 Series Ethernet Switches
II. Analysis
MLD Snooping is not enabled.
III. Solution
1) Enter the display current-configuration command to view the running status of
MLD Snooping.
2) If MLD Snooping is not enabled, use the mld-snooping command to enable MLD
Snooping globally and then use mld-snooping enable command to enable MLD
Snooping in VLAN view.
3) If MLD Snooping is disabled only for the corresponding VLAN, just use the
mld-snooping enable command in VLAN view to enable MLD Snooping in the
corresponding VLAN.

3.9.2 Configured IPv6 Multicast Group Policy Fails to Take Effect

I. Symptom
Although an IPv6 multicast group policy has been configured to allow hosts to join
specific IPv6 multicast groups, the hosts can still receive IPv6 multicast data addressed
to other groups.
II. Analysis
The IPv6 ACL rule is incorrectly configured.
The IPv6 multicast group policy is not correctly applied. If an inexistent IPv6 ACL
or a null IPv6 ACL is used as the IPv6 multicast policy, all IPv6 multicast groups will
be filtered out.
Certain ports have been configured as static member ports of IPv6 multicasts
groups, and this configuration conflicts with the configured IPv6 multicast group
policy.
III. Solution
1) Use the display acl ipv6 command to check the configured IPv6 ACL rule. Make
sure that the IPv6 ACL rule conforms to the IPv6 multicast group policy to be
implemented.
2) Use the display this command in MLD Snooping view or the corresponding port
view to check whether the correct IPv6 multicast group policy has been applied. If
not, use the group-policy or mld-snooping group-policy command to apply the
correct IPv6 multicast group policy.
3) Use the display mld-snooping group command to check whether any port has
been configured as a static member port of any IPv6 multicast group. If so, check
whether this configuration conflicts with the configured IPv6 multicast group policy.
If any conflict exists, remove the port as a static member of the IPv6 multicast
group.
Chapter 3 MLD Snooping Configuration
3-22