Mld Snooping Configuration Examples; Simulated Host Joining - H3C S5500-SI Series Manual

Operation Manual – Multicast Protocol
H3C S5500-SI Series Ethernet Switches
Note:
The reset mld-snooping group command works only on an MLD Snooping–enabled
VLAN, but not on a VLAN with MLD enabled on its VLAN interface.
The reset mld-snooping group command cannot clear MLD Snooping entries
derived from static configuration.

2.8 MLD Snooping Configuration Examples

2.8.1 Simulated Host Joining

I. Network requirements
After the configuration, Host A and Host B, regardless of whether they have joined the
IPv6 multicast group FF1E::1, can receive IPv6 multicast data addressed to the IPv6
multicast group FF1E::1. Figure 2-3 shows the network connections..
II. Network diagram
Source
Figure 2-3 Network diagram for simulated hosts joining configuration
III. Configuration procedure
1) Configuring a VLAN
# Create VLAN 100.
<SwitchA> system-view
[SwitchA] vlan 100
# Add ports GigabitEthernet1/0/1 through GigabitEthernet1/0/4 into VLAN 100.
GE1/0/4
GE1/0/1
RouterA SwitchA
IPv6 Multicast Packets
2-20
Chapter 2 MLD Snooping Configuration
Receiver
HostA
GE1/ 0/3
GE1 /0/2
HostC
Receiver
HostB