Table of Contents
Advertisement
TROUBLESHOOTING
If you have problems with the operation of your EmbaGYN
Exerciser, follow these directions:
Fading display or no display –
The display will begin to fade as the batteries run low, and there will be
nothing on the display when there is no power left in the batteries. Make sure
the batteries are charged and inserted correctly. If necessary, replace them.
(For more information, see "Battery Use" on page 19)
Controls won't work –
The unit may be on LOCK, in which case the display will read "LOCK". Hold
down the Lock button on the side for three seconds. If "LOCK" is not showing
on the display, remove and replace the batteries.
No sensation / No leads alarm –
If you feel no sensation when you use EmbaGYN, first try increasing the
strength level according to instructions. If that does not work, dampen your
hand with water and a little table salt. Holding the Trainer in your hand,
increase the strength gradually. If you don't feel anything, the unit may need
to be replaced.
NOTE: If you are able to feel the sensation in your hand but not in your vagina, you
may have nerve damage. Stop using EmbaGYN and call your physician
23
Pelvic Floor
™
PATIENT DAILY DIARY
The Patient Daily Diary will help you keep track of your EmbaGYN
and your results. Bring the diary with you to your physician appointments,
so your physician can monitor your progress and adjust your EmbaGYN
treatment regimen if necessary.
sessions
™
24
Advertisement
Table of Contents
