Using The Control Panel To Adjust The Sensors, Select The Head Rank, And Set; The Memory Switches - Star Micronics TSP200 Series Technical Manual

SPECIFICATIONS AND OPERATION
4. Using the control panel to adjust the sensors, select the head rank, and set the
memory switches.
Hold down the FEED and ONLINE switches while setting power on, then continue to hold the switches down for the time
necessary to enter the required mode, as indicated below.
Start
Buzzer beeps 1 time.
Release within 2 seconds.
Press both
switches.
Continue to
hold down.
Buzzer beeps twice.
Release within 2 seconds.
Both switches
Continue to
hold down.
Buzzer beeps 3 times.
Release within 2 seconds.
Both switches
Continue to
hold down.
Buzzer beeps 4 times.
Release within 2 seconds.
Both switches.
Continue to
hold down.
Buzzer beeps 5 times.
Release within 2 seconds.
Both switches
Continue to
hold down.
Enters "Adjust Paper-Out Sensor" mode.
Enters "Adjust Paper-Near-End Sensor"
mode.
Enters "Set Head Rank" mode.
Enters "Set Memory Switches" mode.
Resets, then executes test print.
– 6 –