Installing The Customer Display - Star Micronics SCP700 Series User Manual

33
Connect the interface board to the terminal inside the printer and carefully
slide the board into the printer. Next, secure the interface board in place
with the two screws that come with it.
DIP switches
Affix the ferrite core onto the cable (see page 8.)
Plug one end of the cable into the interface board, and the other end of the
cable into the port of your host computer.

Installing the customer display

Make sure that the printer is turned off and unplugged from its power
outlet.
Remove the display connector cover.
Connect the customer display to the terminal inside the printer.
Secure it in place with the clamp and four screws enclosed.
Break away the small piece from the display connector cover as shown in
the illustration below.
You can do this by using a pair of electrician's pliers or a similar tool to clip
the three plastic tabs that hold the piece in place.
Finally, install the display connector cover.