Star Micronics SCP700 Series User Manual page 19

Open the printer cover.
If a paper roll is already loaded in the printer, remove it. Pull up the receipt
printer mechanism and swing it to a raised position until it stops.
Important!
Parts of the receipt printer mechanism become very hot during printing. Be
sure to handle it carefully to avoid personal injury.
Press down on the near-end sensor release with a ball point pen or similar
pointed object, and slide the pointer left and right until it is aligned with the
indicator for the sensor position you want to use.
Sensor Position
1 (Factory Default)
Note:
The above diameters indicate the outside diameter of the entire roll. To ensure
proper operation of the near-end sensor, the cardboard core of the paper roll
should have an inside diameter 0.47 (12mm) and an outside diameter of 0.71
(18mm).
Approximate Roll Diameter
2
3
0.87 /22mm
1.02 /26mm
1.18 /30mm
15