Chapter 1: Printer Setup; Choosing A Place For The Printer - Star Micronics SCP700 Series User Manual

Chapter 1: Printer Setup

This chapter contains important information on setting up your printer. Be sure
to read this chapter carefully before using the printer for the first time. In this
chapter you will learn about:

Choosing a place for the printer

Unpacking and setting up the printer
Installing the ribbon cassette
Connecting to a host computer
Loading roll paper
Inserting sheet paper
Adjusting the near-end sensor
Choosing a place for the printer
Before actually unpacking the printer, you should take a few minutes to think
about where you plan to use it. Remember the following points when doing this.
Choose a firm, level surface where the printer will not be exposed to
vibration.
The power outlet you plan to connect to for power should be nearby and
unobstructed.
Make sure that the printer is close enough to your host computer for you to
connect the two.
Make sure that the printer is not exposed to direct sunlight.
Make sure that the printer is well away from heaters and other sources of
extreme heat.
Make sure that the surrounding area is clean, dry, and free of dust.
Make sure that the printer is connected to a reliable power outlet. It should
not be on the same electric circuit as copiers, refrigerators, or other
appliances that cause power spikes.
Use a power outlet that matches the power rating noted on the label affixed
to the bottom of your printer.
Make sure that the room where you are using the printer is not too humid.
1