Table of Contents
Advertisement
n Installing the interface board
Interface
cover
board
Figure 1-7. Slide the I/F board into the slot.
A parallel interface board comes standard with your printer.
In addition,
there are two optional interface (I/F) boards:
a
serial interface board that lets you connect to a serial (RS-232C)
computer
port; and the other board contains
extra buffer
memory for parallel output. All three boards are installed the
same ,way.
To install or change an I/F board, turn off the power and
turn the printer around.
Notice the snap-on cover at the left
end. Take it off by sliding it upwards.
Fit the I/F board into the side slots and slide it all the way
down (don't force it). Make sur.e that the board connector
is
seated snugly in its socket. Put the cover back on and connect
the cable from your computer - you're ready to go.
Advertisement
Chapters
Table of Contents
