Adjusting The Print Head - Star Micronics ND-10/15 User Manual

16
9. Set the release lever to the auto-feed setting. The printer
will advance the paper automatically.
10. Feed the paper through the slot in the printer cover.
11. Install the paper guide on the printer. See Figure 2-10
for details. When used with sprocket-feed paper, the
guide is turned around and laid flat on top of the printer
as a paper separator. Make sure that the tabs on the
guide fit into their receivers.
Figure Z-10. Ready to load the sprocket-feed paper. Note the reversed
position of the paper.
ADJUSTING THE PRINT HEAD
The distance between the print head and the platen must
be adjusted to accommodate papers of different thicknesses.
To make this adjustment, move the adjustment lever, which
is under the printer cover and immediately in front of the release
lever (Figure 2-l 1). Pulling the adjustment lever towards you
will widen the gap; pushing it away from you will narrow the
gap.