Installing The Closed Position Stop Plate / Push-To-Open - Mighty Mule MM571W Installation Manual

INSTALLING THE CLOSED POSITION STOP PLATE / PUSH-TO-OPEN

Your Property
Step 1
● Remove the operator from the gate post
and gate brackets.
● Swing the gate to the open position.
● With the gate fully open, install the
closed position stop plate on the gate
opposite the operator (hardware not
included).
● Do not fully tighten hardware until after
the next step.
Step 2
● Swing the gate to the closed position,
and adjust the closed position stop plate
against the fence post.
● Tighten the mounting hardware.
● With the gate in the closed position,
reinstall the operator arm.
Note: For MM572W installations, the closed position stop plate should be installed on the leading edge of the PRIMARY gate leaf,
and adjusted to close against the leading edge of the SECONDARY gate leaf.
H
1
MM571W / MM572W Installation Instructions
1
13