Feeding Cut-Sheet Paper Into The Printer - Star Micronics LC-8021 User Manual

Feeding cut-sheet paper into the printer

Use the following procedure to feed cut sheet paper into the printer.
When feeding large paper, such as A4-size paper, pull out the document table
extension.
Check that the control panel's POWER indicator is flashing, which shows
that there is no paper in the printer.
When printing on 4-ply or 5-ply paper, the Multi-Part Mode should be
used. Check to make sure that the control panel's MULTI-PART indicator
is lit. If it isn't, press the control panel's MULTI-PART button.
Insert the paper into the printer as far as it will go, sliding its left side
against the printer's left guide.
Important!
If the paper is not inserted straight into the printer, it will be considered a
loading error and the paper will be ejected. Be sure to insert the paper
correctly.
Inserting the paper with its left side more than 7 mm to the right of the left
guide will be considered an error and the paper will be ejected.
Paper
Document table extension
The paper will automatically be fed into the printer.
If your are using letterhead, make sure the paper is facing up, with the top
towards the printer.
Start the printing operation from your software application.
After the printing is complete, press EJECT to eject the paper from the
printer.
Feeding cut-sheet paper into the printer
Document table
Control panel
37