Star Micronics FR-10 User Manual page 80

If the paperpark facilitydoesnot appearto be workingcorrectly,checkthe
following:
Check
Possible remedy
Is the paperrelease lever in
The paperrelease lever must be set to the ~ position
the ~ position?
afterthe fanfoldpaperhas been parked.
Has the fanfold paper been
Make strrethatthe
PAPER
indicatorcomes on afterthe
WWIY puked?
fanfoldpaperhas been parked.
If theshorttear-offfunctiondoesnot appearto be workingproperly,check:
Check Possible remedy
Has printing ended in the EithersendacFF>orenough <LF>ccmunandstoe ject
middle of a page? the page.
If text is being printed all on one line, or with extra blank lines, check the
following:
I
Check ] Possible remedv
Is
the
text all on the same
tine?
Is
text being printed with
extrablanklines?
Carriage returns are not being expanded to
-& R>+cLF>pairs. ChecktheMemorySwitchSetting
andcorrect.
Two line feeds are being printed. Either make your
software printjust a carriagereturnor (if this is not
possible), set the AUTOLFto OFFusing theMemory
Switch menus.
Ifthepagelengthandmarginsarenotwhatisexpected,checkthefollowing:
Check
Is the printing starting too
high or too low on the page?
Does the printer's page
lengthnotmatchthephysical
page length?
Is the Skip-over perforation
facility not working?
Possible remedy
Use the Micro Feed facility to adjustthe printposition
relative to the wwze.
Use the Memory Switch settings, or the DIP switch to
set up the correct page lengti or use software cOm-
mandsto do it.
Makesure@isis set withtheMemorySwitchmenus.If
the skip occurs in the wrongplace, make sure the page
length is properly se~ and that the top of the print
position is abouttwo lines down from the top of the
uaver.
74