Star Micronics FR-10 User Manual page 79

Check
Are you hying to feed paper
using the frontpanelbuttons
while the ON
LINE
indicator
is illuminated?
You can only feed paperin this way whenthe printeris
off-line. Set the @nter off-line andthen feed paper.
ISthe paper too thick? Therearelimits to thethicknessof paperthatcanbe fed
in this way (one top copy andthreeNCR copies). Try
with thinnerpaper.
If the ASF is not operatingor is not feeding paper carectly, check the
following:
Check
Has the ASF option been
selected using the Memory
Switch functions?
Is the release lever set to the
~ position?
Is the ASF correctly
mounted?
Is paper caught up near the
orinthead?
Are the left andright guides
too close together?
Is theretoomuchpaperin the
paperfeedhopperorstacker?
Was thepaperfannedbefore
being fed into the ASF?
Haathe paperbeen used al-
readyor is it creased?
Are you b-yingto feed paper
using the frontpanel buttons
while the ON
LINE
indicator
is illuminated?
ts the papertoo thick or too
~?
Possible remedy
Select this option
The release lever should be set to the single-sheet
position.
MakesurethattheASF improperly s eatedontheprintcr.
Stopprinting,remove thejsrnmedsheet (you mayhave
to remove the ASF for this), andcontinue.
If the left andright guides are too close together, the
paperwill not feed smoothly.Move thema little further
aW to Mow the paperto feed freely.
The ASF'Spaperfeed hopperandstackercan hold 120
sheets each. Makesurethatthereis no morepaperthan
this in either the hopperor stacker.
If this is not done, paperjams may occur. Remove the
stackof paperfrom the ASF andfan it before reinsert-
ilw.
Only new, uncreaaedpaper should be used with the
ASF.
You can only feed paperin this way when theprinteris
off-line. Set the printeroff-line andthen feed paper.
Therearelimits to thethicknessof paperthatcan be fed
in this way. Try with differentpaper.
73