Star Micronics FR-10 User Manual page 15

2 Pushthe releaselevertowardsthefrontof theprinter(tothe ~ position).
This has the effect of releasingthe paper from the platen roller, and
engagingthe tractorfeed.
3 With the sprocket covers open, tluvad the paper over the sprockets,
aiigningthe sprocketholes withthe pins on the sprockets.
4 Adjustthe spacingof the sprocketsby slidingthem alongthe bar, using
the clamp lever at the back of each sprocketto release and lock the
sprocketimposition (whentheleverisup, thesprocketmaybemoved,and
when it is down,the sprocketis locked).
Release lever
/
Sprocket cover
5 Nowclosethespmcketcovers,againmakingsurethatthe papersprocket
holes are alignedwith the pins on the sprockets.If they are not aligned
properly,you willhaveproblemswith paperfeeding,possiblyresulting
in tearingandjammingof the paper.
6 Tumonthe printerusingthe switchattheback of theprinter.Theprinter
will beep (indicatingthat the paper is not yet fullyloaded).This is also
confirmedby the orange
PAPER
indicator.
9