Escape Sequences In Gl/2 Mode - Star Micronics 4111 Applications Manual

5.8 ESCAPE SEQUENCES IN GIJ2 MODE
When the following commands are given, they have the same results,
whether the printer is in the standard mode or the GL/2 mode.
<ESC> E
the initialization IN command is executed.
. the picture frame is set to its default size.
the frame anchor is set to its default position,
. the plot size is set to its default size.
. the page orientation is reset.
A reset command from the control panel will have the same effect,
<ESC> &/n O
. the orientation of the picture frame is changed.
. the picture frame is set to its default size.
. the frame anchor is set to its default position.
the plot size is set to its default size.
cESC> &a n P
The printing direction command does not effect the orientation or position
of the GL/2 picture frame.
<ESC> &/n P
the picture frame is set to its default size.
. the frame anchor is set to its default position.
. the plot size is set to its default size.,
. P 1 and P2 are set to their default positions.
. the cursor is set to P 1.
the soft clip window is set to its default size.
the polygon buffer is cleared.
126