Star Micronics 4111 Applications Manual page 112

An alternate method of ejecting a page is the Form Feed command. A Form
Feed causes an unconditional page eject and advances the current active
cursor position to the top of form on the next page. The horizontal cursor
position remains the same as before the page eject.
R c s c
~
RO [cwgle :]
This command rotates and translates the plotter coordinate system.
The angle parameter is a clamped integer, O, 90, 180 or 270 (degrees), to
obtain the following results (with respect to the picture frame):
o
Origin at lower left corner, x-axis horizontally to the right,
y-axis vertically up.
90
Origin at lower right corner, x-axis vertically up, y-axis
horizontally to the left.
180 Origin at upper right corner, x-axis horizontally to the left,
y-axis vertically
c
270 Origin at upper left corner, x-axis vertically down, y-axis
horizontally to the right.
The user coordinate system is not affected by this command.
This command does not change the current pen location, only itscoordinates.
The coordinates of P1 and P2 are not changed, so P2 will be outside the
picture frame when cmg/eis 90 or 270. The 1Pcommand should be used after
rotation to correct the situation.
The coordinates of the points defining the soft-clip window are not changed,
and the window is rotated.
S c
SC xmitl, xmax, ymin, ytnax [, type [, lejl, bottom ;]]
or
SC xmin, xjilct,
>'min, .vfact,
hpe [;]
where
.rmin,
>mitl,xmax, ymax, xfact and
?fact
parameters are the real.
The h~e parameter is the clamped integer which can be Oto 2. The left and
bottom parameters are the clamped real, Oto 100.
104