Table of Contents
Advertisement
Within a label, each character begins to the right of the previous character.
This is a horizontal text path (unless altered by DI or DR).
Within a label. each character begins below the previous character. This
is a vertical text path (unless altered by DI or DR).
Within a label, each character begins to the left of the previous character.
This is a horizontal text path (unless altered by DI or DR).
Within a label, each character begins above the previous character. This
is a vertical text path (unless altered by DI or DR).
The /iHeparameter specifies the location of each character with respect to the
preceding character, relative to the labeling direction defined by DI or DR
commands. The line is O,the normal line feed function with respect to text
path direction is selected. The line is 1, the reverse line feed function with
respect to text path direction is selected.
Extra space command
ES }t'idth[, height ;]
This command allows the character and line spacing to be changed. The
values are added to or subtracted from the font parameters. This remains in
effect until the next ES command or the printer is reset.
Select primary font command
FI,j{~n~ i d [:]
This command allows the selection and use as the standard or primary font
any font to which an ID has been assigned. For outline fonts, the SD
command must also be used to specify the point size.
This command executes an SB command to insure compatibility of the font
selected with the font types allowed.
Select secondaryfont command
FNjimt id [;]
This command does for the secondary font what FI does for the primary font.
122
Advertisement
Table of Contents
