Table of Contents
Advertisement
C
f
m
c
CF,fill mode [, edge pt't?:]
This command specifies the way scalable fonts are filled and edged; bitmap
and Stick fontscannot be edged and can be filled only with raster fill, shading,
or cross-hatch patterns. Scalable characters maybe filled with any of the fill
patterns specified by the
FT
command (shading, hatching, cross-hatching,
and user-defined raster fill patterns).
The ,fill mocle parameter specifies how the printer will render filled
characters to the following parameter values.
o
1
2
3
Specifies solid fill using the current pen and edging with the specified pen
(or current pen if the edge pen parameter is not specified).
Specifies edging with the specified pen (or current pen if the edge pen
parameter is not specified). Characters are filled only if they cannot be
edged (bitmap or stick characters). using the edge pen.
Specifies filled characters using the current fill type (refer to the FT
command). The currently selected pen is used. Characters are not edged.
If the edge pen parameter is specified. it is ignored.
Specifies filled characters using the current fill type (refer to the FT
command). The currently selected pen is used. Characters are edged with
the specified pen (or current pen if the edge pen parameter is not speci-
fied).
For characters that are to be edged, the edge pen parameter indicates the pen
that will be used to edge the character. If this parameter is O.the characters
are not edging. If this is 1, black edging is selected.
C
p
c
CP spaces, lines [:]
This command moves the current point horizontally by the value of "spaces"
and vertically by the value of "lines".Horizontal movement is to the right
when
"spaces"
is
positive and to the left when it is negative. Vertical
movement is down when "lines"is positive and up when it is negative.
A CP command with no parameters is the same as <CR>, <LF> within a
label.
120
Advertisement
Table of Contents
