Specifications; Troubleshooting - FujiFilm instax mini Link User Manual

Specifications

Recording method 3-color exposure with OLED
Film used FUJIFILM instax mini Instant Film (sold
separately)
Number of films 10 films/pack
Image size 62 mm × 46 mm
Supported image 800 × 600 dots
size
Printing resolution 12.5 dots/mm (318 dpi, 80 μm dot pitch)
Printing levels 256 levels per color (RGB)
Interface Standard compliance: Bluetooth Ver. 4.2
(BLE)
Supported image JPEG, PNG, HEIF
format
Printing time Image recording - photo output (fed out):
Approximately 12 sec.
Approximate Approximately 100 prints (from full
printing capacity charge)
* The number of prints depends on the
usage conditions.
Power supply Lithium ion battery (internal type: not
removable)
Charging time Approximately 80 to 120 minutes
(Charging time depends on the
temperature and battery remaining level)
Power consumption Approximately 3 W
Operating Temperature: +5 ºC to +40 ºC
environment Humidity: 20% to 80% (no condensation)
Main unit 90.3 mm × 34.6 mm × 124.5 mm
dimensions (excluding projecting parts)
Main unit mass Approximately 209 g (excluding film
pack)
Supplied accessory USB cable (BOD700, Length: 30 cm)
*The above specifications are subject to change for performance
improvement.

Troubleshooting

Please check the following items before considering a problem to
be a malfunction. If the problem persists even after taking action,
please contact the FUJIFILM service center for repair in your
country or visit the website below.
FUJIFILM website: http://www.fujifilm.com/
If the following problem occurs���
Problem Possible causes and solutions
I cannot turn on • The battery may not be charged. Please
the printer. charge the printer.
• You did not press the Power button for
long enough. Press and hold the Power
button for approximately 1 second.
The battery If you use the printer in a very cold
loses its charge environment, the battery will drain quickly.
quickly. Please keep the printer warm before
printing.
The power cut The battery level may be low. Please charge
off during use. the printer.
Charging does Make sure that the USB power adapter plug
not start. is properly connected to the power outlet.
The printer takes At low temperatures, charging may take
too long to longer.
charge.
Charging stops Charge the battery in a temperature range of
during charging. +5 °C to +40 °C. If you cannot charge the
printer in this range, contact your FUJIFILM
dealer or support center.
The printer does • There may be a temporary malfunction.
not function Please press the reset button. If the printer
normally. still does not function normally, please
contact our repair service center for repair.
• The battery may not be charged. Please
charge the printer.
The film pack • Please use FUJIFILM instax mini Instant
does not load or Film (other films cannot be used).
does not load • Align the yellow mark on the film pack
correctly. with the yellow alignment marker on the
printer body, once aligned load the film
into the printer.
The film does • The film may be misaligned due to shock
not unload. such as vibration or dropping. Please load
a new film pack.
• If the film is jammed, turn the printer off
and turn it on again. If the problem
persists, remove the jammed film and
then load a new film pack.
Some or all of Do not open the film door until the film has
the finished been used up. If the film door is opened with
prints are white. film remaining, the film will be exposed and
become white.
WW_EN
11