Intended Use; Assembly - Vermeiren Four Light Instruction Manual

EN
NL

5. Intended use

WARNING: Risk of falling - Do not use
the rollator if you have weak arm
function or poor equilibrium.
The rollator will compensate the lack of
PL
adequate support by the legs by leaning on,
or moving with, the rollator with usage of the
CS
upper limbs or chest. The rollator will provide
a better stability, support and safety during
walking.
However, it cannot be used by persons with a
visible weakened hand and/or arm function
and also not by persons with a balance
problem.
The rollator can be used indoor and outdoor.
The rollator should only be used on surfaces
where all four wheels are touching the ground.
Not to be used on rocky terrain or steep hills
(see technical details: max. inclination) so the
rollator can become unstable.
The product is not meant for transport of
people and/or goods. The seat can only be
used when the parking brake is locked.

6. Assembly

L CAUTION: Chance of pinching - Do
not
components of the rollator.
L
CAUTION: Risk of clamping - Keep
fingers away from moving parts of
the rollator.
1. Mount the rear wheels
NOTE: The brake cable is attached to
the rear wheel. Do not cross the brake
cables.
place fingers between
• Mount the rear
wheel in the frame
of the rollator (rear
side). Be aware for
the brake cables.
• Push the rear wheel
in the tube until the
spring button clicks
in position.
• Check the rear
wheel is firmly
secured.
• Repeat for the other
rear wheel.
2. Mount the front wheels
3. Unfolding rollator
the
• Remove the attachment plate  from
the tube of the seat.
• Unfold the rollator by pushing on the
handgrips.
• Push on the tubes of the seat to unfold
the rollator further.
• Check the seat is firmly secured.
4. Adjust the pushing handgrips to the
desired height (see further).
5. Cane holder
• Attach the cane holder to the side of the
frame by sliding it down over the
receptacle located on the side of the
handgrip height adjustment button.
EN - 2
Four-Light
2017-12
• Mount the front
wheel axle in the
frame of the
rollator (front side).
• Push the front
wheel in the frame
until the front
wheel clicks in
position.
• Check the front
wheel is firmly
secured.
• Repeat for the
other front wheel.
1