Commissioning The Axisdrive Ips; Commissioning The Axisdrive Ips Rf; Fig. 18: Commissioning Axisdrive Ips; Fig. 19 Commissioning Axisdrive Ips Rf - Hettich AxisDrive IPS Operating And Mounting Instructions Manual

7. Operation
7.1.1 Commissioning AxisDrive IPS
Entry for cable of handset

Fig. 18: Commissioning AxisDrive IPS

1. Plug handset cable into the socket (Fig. 18)
2. Secure cable against accidental disconnection by
means of the stress relief (Fig. 18). Also see 5.2.2
Installing the stress relief.
3. Connect mains plug into mains outlet.
4. Your motor-adjustable bed is now ready for use.
20
20
7.1.2 Commissioning the AxisDrive IPS RF with transmitter

Fig. 19 Commissioning AxisDrive IPS RF

Stress relief
Option 1:
1. Put the batteries into the battery compartment of the
transmitter
Ensure proper polarity.
2. Activate learn mode:
Connect mains plug into mains outlet.
The drive is now in "learn mode" for approx. 30 seconds.
3. Encoding
Push the button for lowering the head and foot section on
the transmitter during the learn mode (fig. 17 key )
Successful encoding is confirmed by an acoustic signal.
4. Your motor-adjustable bed is now ready for use.
Option 2:
1. Check that the batteries are inserted in the battery
compartment of the transmitter and that the mains plug
is connected to the mains outlet
2. Encoding
Push and hold the button for lowering the head and foot
section on the transmitter (fig. 17 key ) and push the
coding button on the AxisDrive (fig. 19) at the same time.
Successful encoding is confirmed by an acoustic signal.
3. Your motor-adjustable bed is now ready for use.
(Optional) Entry for cable of handset
Coding button
Note
The two 9V block batteries for emergency
lowering must not be connected during encoding.