6. Commissioning
6.1.2 Connecting the handset / transmitter
Connect the cable of the handset to the 5-pin socket (see
Fig. 18, chapter 7.1.1 commissioning).
Note
You can choose between a handset and a
transmitter to control the double drive!
For more information on the available versions,
see „scope of delivery".
18
18
6.1.3 Connecting the power supply cable
Warning
Warning!
Before connecting the power supply cable, check
again
· that the mains voltage corresponds to the
name plate of the double drive,
· that all components are connected to the right
sockets.
The double drive is ready when the power cable
has been connected and commissioning has been
correctly performed!
Warning
Warning!
Make sure that the cables are not crushed, bent
or stripped when placing them.
Warning
Warning!
Make sure that placement of the cables does not
cause any tripping hazards (e.g. mains
connection cable).