Safety Notes For The User Company; Safety Notes For The Operating Staff - Hettich AxisDrive IPS Operating And Mounting Instructions Manual

3. Safety

3.1 Safety notes for the user company

All persons charged with operation of the double drive
(including supervisors) must be familiar with the chapter
"Safety Notes". The safety notes must be observed.
The double drive must only be operated in an impeccable
condition. The user company must assign clear competences,
e.g. for maintenance, cleaning or repair, and observe the
required training condition for such work.
In addition to this, observe the safety provisions and
employers' liability insurance association provisions in the
country of use.
Do not perform any work that impairs operational safety.
Always use suitable tools for the respective work and remove
the tools after completing the work.
10
10

3.2 Safety notes for the operating staff

The double drive must only be taken into operation when
completely mounted in dry rooms and ready for operation.
Protect the double drive from moisture.
The generally recognised safety-technical and occupational-
medicine rules and the accident prevention provisions must be
observed.
Do not take the double drive into operation if the mains plug
is defective or the double drive has any other visible damage.
Do not replace damaged cables or mains plugs on your own,
but contact a specialist workshop.
Work at the mains connection line must only be performed by
specialist staff.
During commissioning, the operator must ensure that all
safety and protection devices, as well as the operating
elements, work correctly and that there is no damage.
Only operate the slatted bed frame for home use.
Pull the mains plug before relocating the slatted bed frame.
Take the double drive out of operation at once when unusual
events (noise, fumes, smoke, etc.) occur at the double drive.
Disconnect the double drive from the power supply at once.
Have the double drive repaired by a specialist workshop. Only
take the slatted bed frame into operation again after the
repair.
Only operate the double drive in intermittent operation
(IO 2 min / 18 min)
Example: Permanent operation for two minutes at most, then
always take a break of at least 18 minutes.
Alternatively: Permanent operation for one minute, then
always take a break of at least nine minutes.
Avoid electrical and mechanical overload.