To Display And Change Temperature Format (°F/°C) - andrews ECOflo Series Installation And Service Manual

6 Servicing
°F
idle
Fig. 63
°F
idle
Fig. 64
Fig. 65
Fig. 66
70
'Setpoint' flashes
setpoint
'Setpoint' stops flashing
setpoint
°F/°C
°F/°C
'°F/°C' Flashes
4. To lower the temperature setpoint, press the 'Temperature
Down' button until the desired temperature is shown on the
water heater display (Fig. 63).
5. When the desired setpoint is reached on the water heater
display, press the 'Set' button to confirm the new setpoint.
'Setpoint' stops flashing in the water heater display
(Fig. 64).
6.18.6 To display and change temperature format
(°F/°C)
1. While in 'Service Mode', press 'Select' button until
'°F/°C' is shown in the upper right portion of the water
heater display (Fig. 65).
2. Press 'Set' button to change temperature format.
'°F/°C' symbol will flash in the water heater display (Fig. 66).
Issue 2 14/07/16