General - andrews ECOflo Series Installation And Service Manual

High efficiency condensing storage water heaters for natural gas and propane
Table of Contents

Advertisement

3
Installation
Part No.
E910
E860
E865
E862
E863
E236
E205
Part No.
E910
E860
E865
E862
E863
E866
30
3.28.2 ECOflo 380/1900 Horizontal fittings pack – Part
Description
Concentric measure point
Exhaust outlet Tee
100mm concentric exhaust pipe
Air intake "T" piece
Condense syphon
Horizontal terminal 100/150 mm
90º elbow/clamp
3.28.3 ECOflo 380/1900 Vertical fittings pack – Part
Description
Concentric measure point
Exhaust outlet Tee
100mm concentric exhaust pipe
Air intake "T" piece
Condense syphon
Vertical terminal 100/150mm

3.28.4 General

Flue terminals must be installed in accordance with the Clean
Air Act to ensure the results of combustion are properly
dispersed. The drawing on page 25 shows some minimum
clearances for the flue terminal. In addition, the flue terminal
should be positioned where it will not cause a nuisance from
noise or from the combustion waste accumulating. Please
contact Andrews Technical Support Department if advice is
needed for a particular installation.
If installed on a roof valley, the terminal should be at least 1m
above the highest part of the roof structure and 2.5m from any
adjacent structure.
The terminal must be fitted with a guard if less than 2m above
ground level or in a position where it may cause injury to
persons resulting from touching a hot surface. Guards can be
ordered with flue components, see table on page 100.
No: B343
No: B345
Qty
1
1
1
1
1
1
1
Qty
1
1
1
1
1
1
Issue 2 14/07/16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents