Gas Connections; Unpacking; Location; Remove Crate - andrews ECOflo Series Installation And Service Manual

3.10 Gas connections

3.11 Unpacking

3.12 Location

3.13 Remove crate

Issue 2 14/07/16
¾" Gas Inlet Nipple for BSP connection to gas supply.
1" Gas Inlet Nipple for BSP connection to gas supply for the
EC380/1900 model.
INSPECT SHIPMENT CAREFULLY FOR ANY SIGNS OF
DAMAGE
1. All equipment is carefully manufactured, inspected and
packed.
2. Any claims for damage or shortage in shipment must be
filed immediately with Andrews Water Heaters as
detailed on the warranty card
Locate water heater in front of final position before
removing crate.
1. LOCATE so the flue installation connections will be as
short and direct as possible.
2. THIS WATER HEATER IS NOT SUITABLE FOR
INSTALLATION ON A COMBUSTIBLE FLOOR. Do not
install this water heater on carpeting.
3. FOR EVERY INSTALLATION, provide a solid level elevated
base such as concrete or other suitable pad to raise the
water heater at least 150mm to provide a slope for the
condensate waste to run to a suitable drain.
4. Minimum clearance to combustible material is 0" for the Top,
Sides and Rear of this water heater. However, it is
recommended that at least 450mm from the Top, 600mm
from the Front, 100mm from the Left Side and Rear, and
500mm from the Right Side edge of the water heater be
provided for servicing and ease of installation.
See
Section 2, page 10 for diagram. Clearance for
servicing may be reduced down to minimum clearance to
combustible material, but service time and effort may be
greatly increased.
1. Remove all banding and pry off crate sides carefully so as
not to damage the water heater.
2. Carefully roll/lift the water heater from the crate base.
Caution
Do not drop water heater. Do not bump water heater
jacket against floor.
Do not bump exhaust flue pipe against crate or other
objects. This will damage the heater and cause it to be
inoperable or create nuisance problems.
MOVE WATER HEATER TO PERMANENT POSITION
by sliding or walking. Place on plinth/base as detailed
previously.
Installation 3
19