Table of Contents
Advertisement
Operation
This program is the standard cleaning
program for this vehicle.
• Press the green Hako but-
ton (Fig. 17/15) on the left-
hand operating panel.
Various functions can be switched on or
off with the following buttons according
to the conditions at the location of use:
1
2
• Reduce solution quantity (Fig. 22/2)
• Increase solution quantity(Fig. 22/4)
• Solution feed on/off (Fig. 22/3)
• Increase brush pressure (Fig. 22/1)
52
3
4
Check whether the floor is suf-
ficiently dry at regular intervals,
otherwise people could slip. If
the floor is excessively wet,
check the vehicle for leaks and
that the sealing strips are in a
good condition. If the sealing
strips are damaged, change
them; refer to Section 5.8.4.
If you do not want to vacuum the floor
dry in the same working procedure be-
cause you want the solution to soak into
the dirt, for example, activate this pro-
gram.
Wet floors are a potential risk
for slipping! Ensure to provide
the corresponding information
and warning signs.
• Press the "Button for brush
drive" (Fig. 17/9) on the left-
hand operating panel.
Various functions can be switched on or
off with the following buttons according
to the conditions at the location of use:
• Reduce solution quantity (Fig. 22/2)
• Increase solution quantity(Fig. 22/4)
• Solution feed on/off (Fig. 22/3)
• Increase brush pressure (Fig. 22/1)
Advertisement
Table of Contents
