National TESSERA HGT. ADJ. DESK Assembly Instruction page 2

4
Position desk in final location and level the unit using the glides (Figure D).
5
The shroud's interior panels can be removed to access the wire manger by pulling
up to clear the Z-clip then away to free the panel from the shroud (Figure E).
6
The wire manager comes installed on the user's right side shroud. If this is the
preferred location proceed to Step 7. If this isn't the preferred position see the
Wire Manager Relocation section at the end of this instruction to relocate it to the
left side shroud. After this relocation procedure is complete proceed to Step 7.
7
Run power and accessory lines through wire manager ensuring all leads run the full
length of the wire manager.
WARNING: Lines running to worksurface MUST be routed through the full length
of the wire manager to ensure enough lead length is available to support the
mechanism's full range of motion.
8
Replace removable panel back onto the shroud Z-clip hangers.
9
Power up unit and review mechanism manual for recalibration and usage.
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Assembly Instruction
Figure D
Figure E
800.482.1717
TESSERA HGT. ADJ.
DESK
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3206401
Rev, -
.