National Confide Chair Ganging Assembly Instruction

Remove the screws holding the connection
1
bars using a #3 phillips head screwdriver
(Figure A).
Note: Keep the screws and connection bars
for later use.
Determine which side of existing chair
2
for add-on chair. Remove the inserted
caps from the under-seat beam on the
determined side of existing chair.
NOTE: Under-seat beam caps are located
on the bottom side of the chair as shown
in Figure AA.
Remove the finger bracket cover from
3
the back of the add-on side of existing
chair. To disengage press down and out
on the top tab (Figure B).
Place the connection bars into the open
4
exposed beam ends of the add-on chair,
aligning mounting holes. Attach with
two (2) 1/4"-20 x 3/4" truss head
screws per connection (Figure C).
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you have any
questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instruction
Figure A
Figure AA
Figure B
Figure C
Bars
Screws
Confide Chair Ganging
Screws
Recommended Tools
• #3 Phillips Head Screwdriver
Caps
Package Contents
• #1/4"-20 x 3/4" Truss Head
Screw
• #1/4"-20 x 1/2" Flat Head
Screw
• Connection Bar
2 per add-on side
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part #2421495
Rev,A
Printed in U.S.A
© 2012 Kimball International, Inc.
Qty.
4 per bar
2