Safety Regulations; Country-Specific Standards; Assembly And Installation; Commissioning And Testing - Siemens NK8222 Installation, Function & Configuration

Safety regulations

1 Safety regulations
1.1

Country-specific standards

1.2

Assembly and installation

1.3

Commissioning and testing

8
Building Technologies
Fire Safety & Security Products
This section describes the danger levels and the relevant safety regulations appli-
cable to the use of the products described in this manual. Please read the following
work instructions as well as the preceding section About this document thoroughly
before beginning any work.
Danger potential to individuals
NK82xx units are powered with low voltage DC. While there are no specific safety
regulations that apply to these devices, modifications made to safety/security sys-
tems in general may present a risk to the safety of the individual performing those
modifications, as well as to the equipment itself.
If used, the NE8001 cabinet is powered with AC voltage and the required power
cable should be installed following scrupulously the instructions given in this man-
ual.
Siemens Building Technologies products are developed and produced in compli-
ance with the relevant international and European safety standards. This document
provides warnings and recommendations specific to NK8000 products. Any addi-
tional country-specific or local safety standards and/or regulations that apply con-
cerning project planning, installation, operation, and device disposal must also be
taken into account.
As for any electrical equipment, proper grounding is critical to the safe operation
as it provides a protection against electrical shocks. Before starting any activity,
be sure that the electrical installation complies with relevant regulations and con-
forms to local safety standards.
The NK8000 units and NE8000 cabinets should always be installed in a clean and
stable environment; see the specific requirements given in the Technical Data sec-
tion of the specific NK82xx datasheets.
In particular, keep units and cabinets away from the following:
 High levels of dust
 High temperature and humidity
 Locations where it might became wet
 Vibration and impact
Also, abide by the safety regulations of the connected devices.
 Activate security-, fire- and third party systems or devices only in the presence
of the person responsible.
 Inform people before the testing of alarm devices - consider the possibility of
panic reactions.
 Inform the alarm and fault receiving stations connected to the system before
carrying out tests.
048_DMS_NK8000_ICC_MP4.40_A6V10062437_a_en.doc
06.2011