Table of Contents
Advertisement
50
7.18 Lifting and lowering the leg section
WARNING! Always warn the patient before adjusting the leg section of the bed.
The leg section can be adjusted using two "Rastomat" triggered mechanisms with 6
positions (standard) or two, continuous adjustment gas springs (optional code 82700089).
WARNING! Do not place hands or objects between the leg section and the base surface
or the side rails.
7.18.1 Adjust the leg section with the rack mechanism
WARNING! Do not release the leg section if you are not sure it is perfectly locked by the
locking mechanism.
To
lift
the leg section, proceed as follows:
▪ grip and lift the leg section (11) to the desired position, checking it is perfectly locked.
The rack offers the possibility of adjusting the leg section up to 6 different positions.
To
lower
the leg section, proceed as follows:
▪ lift the leg section (11) completely to release the rack mechanism, then lower it again
delicately until it completely rests on the frame of the base surface.
7.18.2 Adjust the gas spring leg section (optional code 82700089)
Foot board movement mechanism activated using the gradual release gas springs, with
adjustment and safety mechanical device. Adjustable using a specific handle on the
bottom of the base surface.
To
lift
the leg section, proceed as follows:
▪ grip the leg section with one hand and use the other to pull the specific lever on the
sides of the section upwards;
▪ lift the leg section to the desired position and release the lever.
lower
To
the leg section, proceed as follows:
▪ grip the leg section with one hand and use the other to pull the specific lever on the
sides of the section upwards;
▪ lower the leg section to the desired position and release the lever.
Adjustable height bed Synago - ID01188 - Rev. 0.0 -
15/11/2015
Advertisement
Table of Contents
