Table of Contents
Advertisement
ID08435 - Rev. 1.2 - 19/04/2023
5.
INSTALLATION
The handling activities described in this chapter shall only be carried out by
qualified personnel specially trained to carry out loading operations in complete
safety, unloading and handling of packages by means of lifting tools such as cranes
or forklifts. Local staff should be aware of the accident prevention rules.
ATTENTION! Ensure that the vehicles and logistic facilities used comply with the
permitted use and in perfect condition; keep away from suspended loads, make sure
that ropes and lifting straps are in perfect condition and properly inserted in the
appropriate hooks.
5.1
Transport and delivery
Transport may be by the following means of transport: road, rail, sea, air.
The weight of the article is deductible from the technical characteristics and
packaging. The handling of the single article must be carried out using
suitable means for handling such as the self-propelled forklift or the manual
forklift.
Occupational safety precautions remain valid.
The device is delivered mounted wrapped with a shockproof bubble wrap film.
ATTENTION! Upon receipt of the device, check with the conveyor that the material is intact,
has not been damaged during transport or has not been opened voluntarily to remove parts
inside. Check that the delivery corresponds to the specifications of the order and verify with
the shipping documents that the delivery is complete.
If the packaging is
damaged internally, open the carrier's presence and check that the
bed has not been damaged.
Note any damage on the shipping documents and immediately inform Pam Mobility
s.r.l.
If the packages are not abnormal, check externally the bed within 24 hours of delivery.
In case of visible damage due to transport, inform the carrier and the insurer
immediately, as well as Pam Mobility s.r.l.
5.2
Lifting
WARNING! Lifting and handling operations must be carried out by specialized personnel
and trained in this type of manoeuvres.
ATTENTION! During the lifting, slowly tighten the belts and verify that no components
not prepared to bear the weight of the group are affected
In order to ensure safe handling of the bed, strictly follow the following instructions:
Make sure that the lifting means are adequate to the weight of the bed.
Use only flat lifting bands.
Place the lifting bands near the trolley frame and not the net frame. If forklifts are
used, place the bed on top of a suitable platform by locking the four wheels.
Raise the bed from the ground as little as possible.
19
Advertisement
Table of Contents
