Battery Charging; Battery Full; System General Error - EBS Active Track Basic+ Operation & Maintenance Manual

Table of Contents

Advertisement

10.7. Battery charging

Once in charger, the device starts charging automatically. It is being signalled
with flashing of "Call me" button.
Note:
When connected device had completely empty battery blue LED may become
darker for about 15 minutes.
If you select "Turn off LEDs when device connected to the charger "in
Advanced" tab (in the option "Device parameters"), the LEDs will be turned off during
battery charging. See chapter Advanced. After removing the device from the charger,
the LEDs will indicate the status of the device again.
If the option "Generate audible signal on server lost" is selected, the device
during battery charging will inform about the loss of connection to the server by using
a special audio signal - 9 short beeps. The signal will also appear when docking the
device in the charging cradle and the device is not connected to the server. See
chapter Advanced.

10.8. Battery full

When battery is fully charged "Call me" button lights up.

10.9. System general error

When error is detected, it is being signalled with alternate flashing of "Panic"
and "Checkpoint" buttons. Contact your service immediately.
Note:
Similar signaling may be visible after powering-up device. It may last for 3
minutes and it does not mean failure.
Battery full
49

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Active Track Basic+ and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF