Example 2.
TCPCONN=1,*1.5,4
Defines that after first failed attempt, next will occur after 1 minute. If second try
will also fail time period will by multiplied by 1.5, and next one will occur after
1.5 minutes. Each next time period will by multiplied by 1.5 until reach of 4
minutes. Next attempts will occur after 4 minutes. If server is disconnected,
attempts to connect will look like that (P means connection attempt, number
means time period in minutes): P, 1, P, 1.5, P, 2.25, P, 3.38, P, 4, P, 4, P, ..........
Default value: 1,+0,1
VOLUME=a,b,c,d,e,f,g
For each of the following events:
a) Start RFID loop
b) Read RFID confirmation
c) Discharged battery warning
d)
e) SMS message received
f)
g) prealarm signalling (eg. ManDown)
You can define one of the following method of signaling:
0 - no acoustic signal, no vibration
1 – quiet acoustic signal, no vibration
2 - loud acoustic signal, no vibration
4 – no acoustic signal, vibration
5 – quiet acoustic signal, vibration
6 – loud acoustic signal, vibration
Note:
Always assign 0 to the d and f positions.
Example: VOLUME=1,2,6,5,0,5,0,6
Start RFID loop
will be defined by quiet acoustic signal without vibration,
confirmation
will be defined by quiet acoustic signal without vibration,
battery warning
will be defined by loud acoustic signal with vibration etc
Note:
It is not necessary to give all the parameters, only the first X, for example:
VOLUME=2 sets the signal only for start RFID loop, the other parameters remain
unchanged. As a consequence, to set the parameter to the position of N all
preceding parameters should also be set. For example, you can not set signaling for
c) Discharged battery warning
"
b) Read RFID confirmation
"
TCPWDT=t
sets GPRS link control, defines times between lost of GPRS connection and reset of
GSM modem.
t - time period [in minutes, range: 5 - 999]
To disable this function t must be an empty string.
" without giving "
" in correct order.
a) Start RFID loo
p" warning and
Read RFID
Discharged
.
16
Need help?
Do you have a question about the Active Track Basic+ and is the answer not in the manual?