Magtek eDynamo Installation And Operation Manual page 33

Appendix A - Technical Specifications
Keypad:
Ingress Protection:
Tamper Protection:
Code Protection:
Eavesdrop Protection:
Power Inputs:
Battery Type:
Battery Capacity:
Battery Charge Time:
Battery Time, Airplane Mode: 6 months minimum
Battery Time, Transactions:
Voltage Requirements:
Maximum Current Draw:
Data Storage:
Wired Connection Types:
Wireless Connection Types:
Wireless Range:
Wireless Frequency:
eDynamo| Secure Card Reader Authenticator | Installation and Operation Manual
eDynamo Technical Specifications
Not Applicable
Security Characteristics
ANSI/ISO 60529 ingress protection rating 30
Secure Cryptographic Device (SCD) with Tamper Resistant Security
Module (TRSM).
Signed firmware. Any attempt to install unsigned firmware on the
device will render it unusable.
Main processor encryption
Tamper-evident enclosure around data signals
Electrical Characteristics
USB powered via Micro-USB B jack
Rechargeable Li-ion (main device power)
Coin cell backup battery
800 mAH nominal
Approximately 3 hours to full charge
1900 swipes over 8 hours
1300 insertions over 5.5 hours
5 VDC on USB power
3.7 VDC on battery power
< 100 mA battery discharge rate when not charging
~500 mA battery charge rate when connected to USB charger
Not Applicable
Connection Characteristics
Micro-USB B, compatible with USB 1.1, USB 2.0
Vendor-defined USB Human Interface Device (HID) data format
Bluetooth Low Energy (Bluetooth LE) wireless
GATT device / data format
Minimum 30 ft. or 10 m in line-of-sight conditions
2.4 GHz
Page 33 of 34 (D998200110-23)