Wiring: 200-240 V, 1 Φ With Line Reactor - BIG ASS FANS Powerfoil X3.0 Plus Installation Manual

Wiring: 200–240 V, 1 Φ with Line Reactor
WARNING: Wait three minutes after disconnecting before servicing!
WARNING: Improper installation can cause electric shock or damage to the motor and VFD! A qualified
electrician should perform the installation.
The diagram below shows a typical line reactor installation on a standard VFD (200–240 V, 1 Φ) using single-phase
input from AC power supply. Actual component layout may differ from illustration.
Note: Fire relay not shown below. See "Wiring: Fire Relay" for fire relay wiring diagrams.
NEMA L6-20P (1.0 hp) or
NEMA L6 30P (1.5–2.0 hp)
Twistlock Plug and
15 ft (4.6 m) Cord
40
BLACK
RED
GREEN
BLACK
AC
Input
Wiring
READY RUN
NPN
PNP PNP
BLACK
RED
BLUE
GREEN/YELLOW
Motor
Output
Wiring
WWW.BIGASSSOLUTIONS.COM
GREEN/YELLOW
BLACK
RED
ON
ON
FAULT
1 2 3
1 2 3
AVI RA RB RC
ACI
ACI
© 2016 DELTA T CORP. ALL RIGHTS RESERVED.
AC Input Fusing
RED
Spare Entry
(½'' NPT unplugged)
Data
Cable