Connecting The Chassis To A Power Shelf - HPE Apollo a6000 Quick Setup Instructions Manual

6. Install the 12V DC power cables:
a. Insert the cable through the wide opening on either end of
the power shelf, and then connect it to the appropriate
connector.
b. Slide the cables toward the center, allowing them to
straighten and hang from the rear of the power shelf.
7. Install the cable guard.
NOTE: Cables are removed for clarity.
8. Install the power supply vent cover to protect the power supply
vents.
Connecting the chassis to a power
shelf
IMPORTANT: To complete this procedure, be sure to
locate the power management cable (part number
745919-001).
To install the component:
1.
Connect the power cables from the chassis power cage to the
power shelf.
2.
Connect the power management cable to the chassis
management module with the cable's plastic tab facing up.
CAUTION: To prevent damage to the power
management cable, release the cable by pressing the
latches when disconnecting, instead of pulling directly.
IMPORTANT: When connecting the power
management cable to the chassis management module
and the power shelf, be sure to install the cable with the
plastic tab on the top of the connector. Failure to install
the cable properly can result in performance and
reporting issues.
3. Connect the power management cable to the power shelf with
the cable's plastic tab facing up.
CAUTION: To prevent damage to the power
management cable, release the cable by pressing the
latches when disconnecting, instead of pulling directly.