Grandstream Networks HT802 Self-Installation And Configuration Manual page 6

9. Scroll down to the bottom, click Apply.
10. Reboot the device.
i. Click Advanced Settings.
ii. Scroll to the bottom and click Reboot.
iii. Close the webpage as it will not update you on the reboot process if open.
NOTE: You can also disconnect and reconnect the power cord to reboot.
The reboot will take about least 2-3 minutes. During this time different combinations of lights will
come on.
When complete, you should see either 3 or 4 lights on top of the ATA (power, network, line-1
status, line-2 status, if applicable), that stay on solid for more than a few seconds.
NOTE: If you do not see the 3 or 4 lights go solid after 4 minutes, go back to step 7 and repeat
the steps.
11. Test the ATA.
To test the ATA, make a phone call from the phone and to the phone to confirm both incoming
and outgoing calls are successful. When you pick up the handset the lights on the ATA may flash.
If a call is connected, both incoming and outgoing, you have successfully configured your ATA.
NOTE: Once configured, you will no longer be able to sign into the device with the credentials
above.
If you wish to connect a different device to your ATA at this time, you can do so. Examples of
analog devices include Point of Sale devices, fax machines, paging systems, and cordless
phones.
ATA Self-installation and Configuration Guide 6