Grandstream Networks HT802 Self-Installation And Configuration Manual page 4

2. Use the ethernet cable to connect the blue ethernet LAN port, located on the back of the ATA, to a
network. After a few seconds, a solid blue light should come on indicating that the network is
connected.
3. Attach an analog phone to the green phone port numbered 1, located on the back of the ATA. Wait
for the ATA to establish network connectivity.
4. Pick up the handset and dial * * * 0 2 (Star Star Star Zero Two) to hear the ATA's IP Address. Write
it down and hang up the phone.
5. From a computer on the same network as the ATA, open a web browser.
6. Enter the ATA's IP address into the address bar and hit enter. This will take you to the Grandstream
Device Configuration page.
7. Use these credentials to login:
•
Username: admin
•
Password: admin
NOTE: If you cannot get to the login you may not be connected on the same network as the device.
ATA Self-installation and Configuration Guide 4