Troubleshooting - Hayward ColorLogic 160 Owner's Manual

1.5 inch led light fixtures

Hide thumbs

Table Of Contents

Table of Contents

Available languages

If you have a problem with your Hayward ColorLogic or CrystaLogic light, please try the following tips

before calling for service:

PROBLEM:

ColorLogic models will not advance to the next program when it is power-cycled

(turned "off" and then back "on").

SOLUTION1: Do not power-cycle the switch too rapidly. Leave it off for at least 1 second before

turning it back on.

SOLUTION2: The light may be in Omni Direct mode. To manually go back to Universal ColorLogic

(UCL) mode, follow the procedure below:

Turn light on and wait 15 seconds for show/color to launch.

Turn off light for between 11-15 seconds, then turn on for 2 seconds.

Turn off light for 1 minute. The light should return to UCL mode and operate

normally.

PROBLEM:

The light goes to white whenever it is power-cycled (turned "off" and then back "on").

SOLUTION:

Be sure that you power-cycle the light for less than 10 seconds.

PROBLEM:

Multiple ColorLogic lights are not correctly synchronized.

SOLUTION:

Refer to page 9. Follow the steps in these instructions to re-synchronize the lights.

PROBLEM:

Light will not come on.

SOLUTION:

Check input power to transformer and then light. Check ground fault and reset if

necessary.

PROBLEM:

Light will not come on or light cycles on and off.

SOLUTION:

Depending on cord length and operating voltage, automatic thermal switch may be

cycling due to excessive air/pool water temperatures (over 105ºF). For ColorLogic

lights, temporarily switch to a cooler color (Deep Blue Sea, Royal Blue, etc.) until air/

water temperatures cool off.

PROBLEM: GFCI trips when lights are turned on or off.

SOLUTION: Install a Hayward GLX-HAL-XSNUB snubber capacitor across the primary leads (line to

neutral) of the transformer on the load side of the light switch or relay.

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS