Install Wiring Using A Hayward Junction Box Transformer - Hayward ColorLogic 160 Owner's Manual

Install Wiring using a Hayward Junction Box Transformer

Hayward offers pool/spa light transformers designed to fit into various manufacturer's junction boxes.
Refer to the table below to determine which model transformer will fit your type of junction box.
These transformers are designed to power up to two Hayward ColorLogic and/or CrystaLogic 1.5"
LED lights. If more than two lights are installed, multiple junction box transformers must be used.
Run conduit from the junction box transformer to the pool/spa controller or switch box. Snake 3
wires through the conduit. Connect the ground wires to the ground terminal connections inside the
junction box. Use wire nuts to connect the field-installed wiring to the 120V side of the transformer
and the 1.5" LED light cord to the low voltage side of the transformer. Refer to wiring diagram on
the following page.
7
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
To Hayward
1.5" LED Light
To Hayward
1.5" LED Light