Pvc Conduit Run; Install The Led Light Into Pvc Conduit - Hayward ColorLogic 160 Owner's Manual

PVC Conduit Run

Install PVC from the desired installation location of the light, back to the transformer. For ease in
pulling the ColorLogic/CrystaLogic's cable, use long sweeps only (no more than 3), no 90º elbows.
Finish the run before installing the light. Do not attempt to glue PVC or fittings while routing the cable.

Install the LED Light into PVC conduit

With the PVC conduit secure in the pool wall, follow these steps to secure the light:
1) Run the ColorLogic/CrystaLogic 1.5" LED light cord through the conduit to the transformer or
junction box location.
2) Insert the ColorLogic/CrystaLogic 1.5" LED light fully into the conduit as shown. IMPORTANT:
Do not use silicone or any other type of sealant.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
INSIDE POOL
4