technical bulletin
XJ200 Installation and Operating Instructions
2. Close the jumper found inside the XJ200 by inserting the micro switch as shown in the
picture below.
Figure 8 - Micro Switch
3. Close the cover of the XJ200 once again.
4. Connect the XJ200, PW200J and the X-WEB as shown in the connection diagram below.
Figure 9 - XJ200 and X-WEB Connection
NOTE: When using the XJ200 with an XR, XM, or XEV controller, the XJ200 external power supply
must be used.
Document Part # 026-4833 Rev 0 26-FEB-2013
Page 7 of 17
©2013 Emerson Climate Technologies Retail Solutions, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emersonclimate.com/ for the latest technical documentation and updates.