Table of Contents
Advertisement
technical bulletin
XJ200 Installation and Operating Instructions
E2 and XJ200 Networking
XJ200 Wireless New Installation Procedure
E2-XJ200 Master Connection
In the new installation, you need to find a location in the store that has a direct line of sight
with at least one or two wireless modules (slave modules) on the sales floor. If the system
performs up to four hops, those in the indirect view can find their way to the master wireless
module location to them.
Figure 12 - XJ200 Wireless
From the designated position, run a communication cable (three conductors) and wiring to
handle 24VAC, and depending on the distance, the wire gauge needs to be calculated. The
master module needs a power supply that takes 24 VAC and powers the wireless module
with 5VDC.
Document Part # 026-4833 Rev 0 26-FEB-2013
Page 10 of 17
©2013 Emerson Climate Technologies Retail Solutions, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emersonclimate.com/ for the latest technical documentation and updates.
Advertisement
Table of Contents
