Handset Administration; Faqs - SpectraLink NetLink 8000 User Manual

HANDSET ADMINISTRATION

FAQs

How does the handset power off and power on?
The key is the power on/power off key. Press and hold it to
END
turn the handset on. Turn the handset off from the standby mode
by pressing and holding the key. If you are in an active call, end
END
the call by pressing the key. This returns the handset to the
END
standby mode, then press again to turn the handset off.
END
How do I place a call and terminate a call?
To place a call, press the key and then dial the number. End
START
the call by pressing the key. You can also use the speakerphone
END
instead of the key.
START
Can I change the ring?
The ring is fully adjustable and may be set differently for different
profiles. For a complete explanation of how to change the ring, see
the Profile Settings section of this guide.
How do I change the voice volume and the ringing volume?
Whether using a headset, the speakerphone, or the internal
speaker, the speaker volume for the current call may be raised or
lowered by pressing the up and down volume buttons on the side
of the handset.
The volume buttons may be pressed while the handset is ringing to
raise or lower the ring volume, which also changes the ring volume
setting in the current profile.
What is the range of the NetLink 8000 Series Wireless
Telephone?
As barriers affect radio transmission, there is no single answer for
this question. Normally, you can expect the same range as with any
other wireless device. However, if your facility has metal walls or
other materials that inhibit radio waves, the range will be reduced.
How do I charge the Battery Pack?
The Battery Pack in the handset may be charged in a Single or Dual
Charger without being removed from the handset by simply plac-
37