Advertisement
Setting the protection devices
The Ethernet-system interfaces of the SIPROTEC-protection devices must all be assigned with
different
IP-addresses. The IP-addresses of the PC's, the routers and other devices in the network may not be
assigned again.
For the purpose of setting the Ethernet-system interface (EN100), a connection via the front interface
of the relevant device is created with DIGSI 4. Thereafter, „Object Properties..." is opened with the
right mouse button.
In the window „Properties" the IP
addresses of the protection devices can
be assigned under „Communication
parameters".
The „IP address" must be allocated in
the same subnet range as the router.
(here 192.168.20.xxx).
The „Subnet mask" 255.255.255.0
allows for the allocation of addresses to
254 devices (incl. PC, Router, etc.).
The IP address of the ISDN router is
always used as the „Standard gateway"
All other entries should not be changed.
Close the window with „OK" and save the settings in DIGSI and the protection devices.
HELP_DIG48_SIP4_INSYS_MOROS_ISDN_EN100_EN1.DOC
Seite 4 von 25
Power Transmission and Distribution
Energy Automation
27.08.2008
Advertisement
