Updating Director Class Switches; Performing The Upgrade - Intel Omni-Path Switch 100 Series Installation Manual

You can check the progress of the update with the CLI command
showLastBcFwRetCode -all
following:
Edge-> showLastBcFwRetCode -all
Module Board Controller Firmware Last Exit Code: 3: In Progress
Edge-> showLastBcFwRetCode -all
Module Board Controller Firmware Last Exit Code: 0: Success
Proceed to Step 3.
3. Reboot the switch.
4. Verify the version of the BCFW and BIOS by running the CLI commands
bcfwversion
to the following:
Board Controller Firmware Version: CGBCP429
System BIOS Version: QA3ER962
A.5

Updating Director Class Switches

Update the BCFW and BIOS on Director Class switches (DCS) using the instructions in

Performing the Upgrade

NOTE
The instructions upgrade both the Master and Slave MM.
A.5.1 Performing the Upgrade
1. At the master MM prompt, enter the following command to update the master and
slave:
The system returns information similar to the following:
Uploading QA3ER962.q7.spkg to /firmware/A:/firmware/bios.pkg
QA3ER962.q7.spkg
100% 8193KB
You can check the progress of the update with the CLI command
showLastBiosRetCode -all
following:
MasterM201-> showLastBiosRetCode -all
M201 System BIOS Last Exit Code: 3: In Progress
M202 System BIOS Last Exit Code: 0: Success
MasterM201-> showLastBiosRetCode -all
M201 System BIOS Last Exit Code: 0: Success
M202 System BIOS Last Exit Code: 0: Success
NOTE
DO NOT REBOOT AT THIS TIME. Wait until both the BCFW (via
the BIOS (via
Proceed to Step 2.
®
Intel Omni-Path Fabric Switches Hardware
Installation Guide
88
and
biosversion
on page 88.
sftp> put QA3ER962.q7.spkg A:/firmware/bios.pkg
12.4MB/s
; see Step 2) have been updated, then reboot.
biosupdate
®
Intel Omni-Path Fabric—Q7 BIOS Update
. The system returns information similar to the
. The system should return information similar
00:00
. The system returns information similar to the
) and
bcfwupdate
June 2019
Doc. No.: H76456, Rev.: 10.0