Panasonic AFP0HC32ET User Manual page 83

 Restrictions on combinations of operands [S1] and [S2]
"A" in the table below indicates the available combinations. An operation error occurs when
other combinations are specified.
ALL
S1 EIP
• Read content 1 (When S1 is "EIP" and S2 is "ALL" or "ALL + Number": 1 to 6 words)
Name
Max. registration node number
Cyclic communication registration node table
Cyclic communication normal node table
Cyclic communication stop node table
Cyclic communication abnormal node table
RUN/IDLE bit monitor (PLC standby flag)
• Read content 2 (When S1 is "EIP" and S2 is "NODE": 1 to 2 words)
Name
Max. registration node number
Cyclic communication registration node table
• Read content 3 (When S1 is "EIP" and S2 is "NORMAL": 1 to 2 words)
Name
Max. registration node number
Cyclic communication normal node table
• Read content 4 (When S1 is "EIP" and S2 is "STOP": 1 to 2 words)
Name
Max. registration node number
Cyclic communication stop node table
6.1 High-level Instructions Used for EtherNet/IP Control
NODE NORMAL
A A A
S2
STOP ERR
A A
No. of
Description
words
1 Registered maximum node number
0 to 1
Node that connection is registered
(Note 1) (Note 2)
0 to 1
Node that the cyclic communication is
performed normally
(Note 1) (Note 2)
0 to 1
Node that the cyclic communication stops
(Note 1) (Note 2)
0 to 1
Node that the cyclic communication error
occurs
(Note 1) (Note 2)
0 to 1
RUN/IDLE bit monitor of 32-bit header
(Note 1) (Note 2)
No. of
Description
words
1 Registered maximum node number
0 to 1 (Note 1) Node that connection is registered
No. of
Description
words
Registered maximum node number
1
Node that the cyclic communication is
0 to 1 (Note 1)
performed normally
No. of
Description
words
1 Registered maximum node number
0 to 1 (Note 1) Node that the cyclic communication stops
PLC
A
6-5