Panasonic AFP0HC32ET User Manual page 66

Tool Operation
(3) Scan List Communication Load State
Shows the calculation result of the communication load of the communication in which the
FP0H is originator.
Item
Load Factor Breakdown
Adapter (Target) Load Factor
Node Name
Connection Name
Scheduled Number of
Connected Units
RPI (ms)
Input
COS
(T>O)
MultiCast
(pps)
Scheduled
Connected RPI
Output
(ms)
(O>T)
(pps)
(4) HUB Switch IGMP Snoop Function
Select make the function "Valid" or "Invalid" when calculating the load factor. When selecting
"Invalid", "HUB Switch IGMP Snoop Function" is displayed in red.
* If the adapter (target) load factor exceeds 100% when setting the multicast communication,
change the set value of RPI longer or use a HUB that the IGMP snoop function is enabled.
4-16
Description
Shows the load factor breakdown of each target.
The load factor calculated from the communication band defined in EDS files of
each target.
Shows a node number and node name.
Shows a connection name.
The scheduled number of connected units is displayed.
The RPI (communication interval) in the receiving direction of connection
settings is displayed.
When "Input Send Trigger" is set to "Change of State", '●' is displayed.
When "Connection Type" is set to "Multicast", "●" is displayed.
Shows the communication volume (pps) per second in the receiving direction.
Shows the RPI (communication interval) in the sending direction set in
"Connection Setting".
Shows the communication volume (pps) per second in the sending direction.