Advertisement
Installation
Connections are provided for either a 6-pin PS/2-style or a 5-pin Extended AT-style keyboard. Do
not connect both keyboards simultaneously. Because the Hot Key Mode operation (page 6) re-
quires full PS/2 keyboard functions, a PS/2-style or an Extended AT-style keyboard, which supports
these functions, is recommended.
You may simultaneously connect PS/2 and AT computers to CompuSwitch with the appropriate
cables. However, only a PS/2 mouse can be used with CompuSwitch to operate the computers.
The following procedures will show you how to install the CompuSwitch :
1. Plug the monitor, keyboard, and PS/2 mouse into the ports marked VGA monitor,PS/2 or AT
keyboard, and PS/2 mouse on the CompuSwitch rear panel. Refer to figure 1.
Caution: Make sure that all computers are powered OFF before they are connected to
CompuSwitch.
2. Using the appropriate CompuSwitch cable, connect the 25-pin connector to any channel on the
CompuSwitch rear panel .
Figure 1: The rear view of CSW-8
Figure2: CompuSwitch cable connections
19" Rackmount CompuSwitch 3
Advertisement
